Journal Search Engine
Search Advanced Search Adode Reader(link)
Download PDF Export Citaion korean bibliography PMC previewer
ISSN : 1225-0112(Print)
ISSN : 2288-4505(Online)
Applied Chemistry for Engineering Vol.20 No.3 pp.241-250
DOI :

Invited Review Article : Preparation and Characterisation of Titanium Dioxide Produced from Ti-salt Flocculated Sludge in Water Treatment

Ho Kyong Shon

Abstract

During the past few years, titanium salts were investigated as alternative coagulants for the removal of organic matter of different molecular sizes in contaminated water. The flocculation efficiency of Ti-salt was comparable to those of FeCl3 and Al2(SO4)3 salts, commonly used coagulants. Incinerated sludge-TiO2 showed higher surface area and photocatalytic activity than commercially available TiO2. Metal-doped forms were produced by adding coagulant aids such as iron (Fe-), aluminium (Al-) and (Ca-) calcium salts during Ti-salt flocculation to increase pH. Ca- and Al- doped TiO2 showed very high photocatalytic activity compared to Fe-doped TiO2. When tested in a pilot scale plant for treatment of dye wastewater to check practical feasibility of the novel process, the removal ratio of the chemical oxygen demand was comparable to those of commonly used coagulants but the settling of sludge was faster. The TiO2 generated after sludge incineration showed a high photocatalytic activity for degradation of volatile organic compounds and increased the rate of hydrogen production by water photosplitting. TiCl4 coagulant and TiO2 produced from different water sources with different concentrations had low acute toxicity compared to heavy metals and commercial TiO2 when examined based on D. Magna mortality. This paper presents the production, characterisation and the photoactivity of TiO2 produced from Ti-salt flocculated sludge. Different case studies are discussed to highlighted recent advances in this field.

초청총설논문 : 수처리 티탄염 응집 슬러지에서 생산한 산화티탄의 제조와 특성 조사

손호경

초록

지난 수 년간 본 연구팀은 새로운 티탄염 응집제를 이용하여 폐수를 응집한 후 생산된 슬러지에서 산화티탄을 생산하는 연구를 진행하였다. 티탄염의 응집 효율은 일반적으로 많이 사용되는 철염과 알루미늄염 응집제와 비슷하였으며 슬러지를 소성하여 제조한 산화티탄은 상용 산화티탄보다 더 넓은 표면적과 높은 광촉매 활성을 나타내었다. 산화티탄의 광촉매 활성 향상과 pH를 높이기 위해 응집보조제로서 철, 알루미늄, 칼슘을 사용하여 광촉매 활성이 높은 Fe, Al, Ca 도핑 산화티탄을 제조하였다. 이 기술의 실제 적용 가능성을 확인하기 위하여 염색폐수 파일럿 장치에 적용한 결과, 우수한 유기물 제거 능력과 빠른 응집체 형성이 확인되었다. 염색폐수 슬러지에서 제조한 산화티탄은 높은 유기물 제거 광촉매 활성과 물 광분해에 의해 수소를 생성하였다. 티탄염 응집제와 슬러지에서 제조한 산화티탄의 독성을 D. magna로 조사한 결과, 낮은 독성을 확인할 수 있었다. 이 총설은 미래의 슬러지 재활용 기술로 높은 적용 가능성을 가지는 티탄염으로 제조한 산화티탄의 특성을 체계적으로 정리하였다.

Figure

Table